Author MK Marina
So, what we need: fabric for embroidery (my flax), a needle with a wide eye, an ordinary sewing needle with a simple thread, thick needle (to correct tape), do a tape (for that roses need the tape width of 13 mm) and scissors, hoop.
To begin with, to fill in the tape iglu.Otrezaem centimeters long tape diagonally 40.Srez do, the better to thread the belt in an igloo
bit and stretch the tape to stick the needle tip, stepping back from the edge of a centimeter
like this obrazom.Zatem stretch the tape as if tightening the noose
Tape securely fixed in the eye of the needle.
After, take the free tip of the tape and bend it for about 1 centimeter
pierce the needle
and stretch the needle through with ribbon bent tip lenty.U we got instead of the usual tie-knot, which we do on the tip of the thread.
Lay off to the side while our needle tucked ribbon.
We proceed to the most rozochke.Vyshivka it will take place in 3 stages.
1) We need to make the central part of the rozy.Dlya cut off a small piece of tape (preferably a shade darker than the main part is embroidered with roses), and do three-dimensional rose.
Wrap the left edge of the tape downwards at an angle of 90 degrees.
Founded oborochivaem edge, forming the so-called trubochku.Nizhny edge of the tube reinforcement stitching thread in the color of the tape (picture contrast thread for clarity)
Further, it is necessary to bend the ribbon at an angle from the flower to the outside so that the top edge of the tape has appeared at the bottom, and make a full circle around the tube (core) .Zakreplyaem coil at the base through all the layers of the tape.
Again, we turn down the tape down and make new vitok.Tak many turns as your heart desires) The main thing to fix all the turns ordinary nityu.Zakreplyaem thread, trim it and lentu.Poluchaetsya approximately the rosette
2) At the second stage to sew our rosettes conventional filament fabric
Now, stepping back a few millimeters from the small rosettes-serdtsevinki, we take our needle tucked ribbon and piercing the fabric from the inside, pull the needle to the front, fully stretching tape
stepping back a few millimeters from the place where the needle came out, inject it into the fabric and stretch down
forming a loop
We are helping to shape a needle that should turn lepestok.Vot
Then embroider the petals around serdtsevinki
and that's what eventually
3) The third stage begins in the same way as vtoroy.Prokalyvaem tissue from the inside, having receded somewhat from the first row of petals rose on top, pulling the needle with the tape on the front and embroider storononu 3-4 lobe same loop
further to rosette looked as if lying on its side, do a little more lepestochki.Vytyagivaem tape on the front side, straighten, we do loop
stitch and embroider with curls, that is to stick a needle on top of the tape, stretch it down and tightening, forming a curl.
Thus closes the second row lepestochkov.Ya think, in the process, you will understand how to do the petals to Rose looked more estestvenno.Chem will no longer do the loop, the petals will look more magnificent, and rose more volume. You should try to embroider the petals lying close to each other.
Fix the tape from the inside ordinary nityu.Obrezaem thread and tape.
It was such a rose
And it looks almost finished work
No comments:
Post a Comment